Sometimes,
there's just no substitute for a good 'ol Bridgeport
and a manual lathe.
We've
always had these machines and all of our machinists
know how to put them to work when a project calls for
a hand touch or special operation that we can't perform
on our automated equipment.
Our
conventional department also gives us the capability
to fabricate prototypes and multiple versions of parts
before they go to full production. This is a flexible
and cost effective method to test a design and keep
the ability to make changes.
|
|
|
| We've
made everything from small medical parts to very
large aircraft Wing Slings that were used to lift
and hold an aircraft wing while it was fastened
to the fuselage of fighter jets at McDonnell Douglas.
When the job calls for a hand-made part, we're
on it, ready to deliver fine craftsmanship with
a high level of quality and precision.
|
|
 |
 |
 |
|
